I hope I got the right measurement for you Roberto. I included a image with the measurement points that I took on the CargoBuckle Ladder Rack Straps #CB32MR below. If you are needing a different measurement please let me know.

When using a single set of tire chains on a vehicle that is 4 wheel drive or all wheel drive you want to install the chains on the primary drive axle. Typically this will be listed in the owner's manual. But for a 4WD drive vehicle the axle…

The Kenda 4.80-12 Bias Trailer Tire with 12" Galvanized Wheel - 5 on 4-1/2 - Load Range B #AM30590 have a max speed of 65 mph. When trailer tires are not speed rated with a letter, the default is 65 mph max. I've attached an article…

When the Powerbuilt Unijack #ALL620470 is in it's lowest position it's overall height is 8-5/8 inches. When fully extended the height is 18-3/8 inches.

I went out to the warehouse to measure BoatBuckle G2 Retractable, Ratcheting Transom Tie-Downs #IMF08893. The overall width at the widest point is 4-5/8 inches. The mounting hole is right in the center so from either edge to the center of the…

It is not recommend to jack up a trailer by the axle. This may cause damage to the axle itself. It also puts too much stress on the leaf springs. Instead, you will want to place the jack under part of the trailer frame preferably next to the leaf…

The Powerbuilt Unijack #ALL620470 referenced in your question has a weight capacity of 4,000 pounds. This is likely enough for your 8,200 pound trailer, but I recommend going up a bit with the Unijack #ALL620471 that is rated for 6,000 pounds. This…

The TruRyde Spindle Nut #165686 has an outer measurement of 1.45 inches. You will use a 1-1/2 inch socket on this castle nut or we usually use a channel lock for these installations. I've attached a video of an installation of a hub to assist.…

The roof rack I recommend for a 2020 Jeep Grand Cherokee Trailhawk is the Rhino-Rack RVP Roof Rack part #RRRVP27. The Rhino-Rack RVP installs using fixed mounting points inside the flush side rails therefore you will get a very clean look with simple…

Since Valley went out of business there are no direct replacement parts that are available but a repair kit like the Curt #C25194 for 2" Curt Couplers may be compatible. What I recommend doing is replace your coupler completely as replacement…

I have a great mud flaps solution for you. Unfortunately, the only set of WeatherTech Mud Flaps that fit your 2022 Ram 3500 dually #WT110108 are only confirmed to fit the front fenders on vehicles without fender flares. If front flaps are what you…

The replacement landing gear motor you referenced, Stromberg Carlson #LG-142178, is a widely compatible replacement motor that will work with most major brands of 5th wheel landing gear, including Stromberg Carlson, Lippert, Venture and Atwood. These…